Radio System Corporation PRF-3004W-20 Manuel d'utilisateur Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 25
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
www.petsafe.net 19
Accessories
To purchase additional accessor ies for your PetSafe
®
In-Ground Fence
, visit our website at www.petsafe.net to locate a
retailer near you and for a listing of Customer Care Centre telephone number s in your area.
Component Part Number
Replacement Receiver Collar Battery - two pack RFA-67D-11
Power Adapter for the Fence Transmitter RFA-392
Replacement Collar Strap RFA-41-1
UltraLight
Add-A-Dog
®
Receiver Collar PIG19-10761
Deluxe UltraLight
Add-A-Dog
®
Receiver Collar PIG19-10764
Stubborn Dog Add-A-Dog
®
Receiver Collar PIG19-10763
Additional Boundary Flags RFA-2
Additional Gel-fi lled Capsules and Wire Nuts RFA-366
Wire & Flag Accessory Kit PRFA-500
Accessory Pack RFA-281
Fence Transmitter RFA-347
Wire Break Locator RFA-50
Add-A-Dog
®
Additional Receiver Collars - Instructions for Use
PIG19-10764
Deluxe UltraLight
Add-A-Dog
®
Receiver Collar
This unit has 4 adjustable lev els of Correction plus a Tone Only mode.
Prepare the Receiver Collar
There are two sets of Contact Points that can be used on y our receiver. Your Receiver Collar comes
with the short Contact Points installed. The longer Contact Points should be used on dogs with long
hair. Tighten the Contact Points using the Test Light Tool (A) to one-half turn beyond finger tight.
Check the tightness weekly.
To Insert and Remove the Battery
Please see Step 5 of this manual.
A
To Set the Static Correction Level
Read all steps before attempting to set the Sta tic Correction Level.
1. Remove the clear plastic co ver with the Test Light Tool to expose the Cor rection
Level Button (B).
2. With the battery installed, press the Correction Level Button and release when the
Receiver Indicator Light comes on ( C).
3. The Receiver Indicator Light will emit a ser ies of flashes representing the Static
Correction Level.
4. Increase the Static Correction Level by pressing and releasing the Cor rection Level
Button within 5 seconds of the previous ser ies of flashes.
5. After setting the Static Correction Level, replace the cover to protect the Cor rection
Level Button.
B
C
The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver Collar
is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to choose the Sta tic
Correction level that best fits your pet.
The Receiver Collar is equipped to automa tically increase the level of Static Correction the longer your pet remains in the
Static Correction Zone if the collar is set a t level 2 or above.
The Receiver LED Indicator Light acts as a low battery indicator, flashing every 4 to 5 seconds when replacement is required.
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Commentaires sur ces manuels

Pas de commentaire